Short T & H with an insulatedpiece of wire (14 gauge) to run the motor. Place each of the multitester's leads on a terminal. Closely examine your water inlet valve. Using Pliers, remove the wire harness connecting to the terminals on the Water Inlet Valve. Test points T & H will verify if the bimetal thermostat is open or closed. By continuing to use this site you consent to the use of cookies on your device as described in our cookie policy unless you have disabled them. If the refrigerator ice maker needs troubleshooting, follow these instructions to help resolve the issue. Your multitester should display a reading between 200 and 500 ohms.

Set your multitester to the R X 1 ohms setting to test for continuity. If no water comes into the ice maker during the test for the water valve, check the fill tube for the ice maker next. (Make sure your test probes go into the test points 1/2".) Set the multi-meter to R X 1 ohms to test for continuity. Areas of the part should be marked for testing.

The exact ohm resistance rating you should test for may be marked on the valve. Be sure to label the placement of the wires before disconnecting them. Test points L & N will verify 120 volts to Ice Maker module. How to test a solenoid for power on ice maker side, water side works fine - Answered by a verified Appliance Technician We use cookies to give you the best possible experience on our website. If it’s still on or jammed, continue reading.