Defective Ice Maker The ice maker works with a small motor and most times a small circuit board. I have a GE GFSS6KKYSS with a Samsung IMC701 ice maker and it has just stopped making ice. I had this happen to me just a few days ago. This didn’t work, see details in prior posts. And such a simple solution, at least it worked for me. I had this happen to me just a few days ago. (06/23/2008)

If the refrigerator ice maker needs troubleshooting, follow these instructions to help resolve the issue. Our Samsung French Door refrigertor ice maker stopped working a month ago.

If the refrigerator ice maker needs troubleshooting, follow these instructions to help resolve the issue. (If any of these parts are found to be faulty, it may be best to purchase a new ice maker as this may be more cost effective.) This will likely resolve the issue. This will likely resolve the issue. The … I have to pull/ remove the ice making unit out of the refrigerator to extract the stuck ice out of the freezer tray. Luckily, you can resolve this all on your own by following our simple how-to guide! Remove some of the ice inside the ice storage bin if the bin is too full. Then turn … If the arm will not lower, do not force it, as it could break the arm. If you find ice inside the ice mold, it means your ice maker is receiving water and the problem likely isn't with the water supply. I decided to try turning the freezer temperature down a little to see if that would make any difference. This causes the ice maker to jam up and not make any more ice until it gets cleared out. I decided to try turning the freezer temperature down a little to see if that would make any difference. I removed the ice maker from the fridge and the fingers seemed to be stuck attempting to push the ice out of … read more I have a GE GFSS6KKYSS with a Samsung IMC701 ice maker and it has just stopped making ice. Remove jammed ice from the ejector arm using only a plastic utensil so the ice maker is not damaged. As water continues to flow over the stuck ice, it continues to form to the point where it becomes a massive block of ice. I was so relieved when it did start making ice again. If the ice maker control arm is stuck in the "up" position and there is ice in the ice maker, defrost the freezer. The meter shouldn't give any reading, due to the open circuit. Get shopping advice from experts, friends and the community! I was so relieved when it did start making ice again. Ice makers freeze up when ice can’t release off the evaporator plate. Our Samsung French Door refrigertor ice maker stopped working a month ago. Check the Ice Maker Mold Thermostat, Ice Maker Mold Heater, and the Ice Maker Module. Kenmoore side by side The last piece of ice (cube) gets caught in the fingers that force the ice out of the maker. If ice cubes get stuck in an ice maker you may want to use a thin knife to prick some of the ice so it falls out. The Ice Maker Module includes a motor that ejects the ice out of the ice maker mold tray.

I have to pull/ remove the ice making unit out of the refrigerator to extract the stuck ice out of the freezer tray. I am so bummed about this as it's the first time we have a fridge with an ice maker in the door. Ice Maker Arm is Stuck. Summary: Ice Maker Working. Cost =$130. This is a common problem that causes much annoyance when trying to dispense ice. Instead, it's most likely a mechanical or electrical problem.
If one of these components located in the ice maker itself fails, the ice maker needs to be replaced. First, ensure that ice is not jammed in the ejector arm of the ice maker. First, ensure that ice is not jammed in the ejector arm of the ice maker. If it’s still on or jammed, continue reading. First step was installing a new ice maker. And such a simple solution, at least it worked for me.

Remove and replace the ice maker. Is your ice maker freezing all your ice together and not making ice anymore? The ice maker stopped working in late March. The ice gets stuck on the ejection fingers which push ice out of freezer tray into ice holding tray. If it’s still on or jammed, continue reading.

To troubleshoot an ice maker arm that will not lower: If the arm is locked in the "up" position, firmly press down on the arm to lower it. How to Repair an Ice Cube Jam in an Ice Maker Dispenser.
Remove jammed ice from the ejector arm using only a plastic utensil so the ice maker is not damaged.